Works if you fool the machine into moving the cartridges to the left and then pulling out the power lead. Trying to get the small pads out from under the cartridges. It should blink for two to three seconds, then stay lit this will indicate that the printer has been reset and is ready to print again without errors. Continue holding the power button down until the printer begins to reset itself and come online.ħ Wait for the green power light to turn off, then press and release the power button again. Replace the rubber frame in its original position and close the printer.Ħ Hold down the power button, then plug the printer back in. Carefully remove the ink absorber pad or pads from the rubber frame.ĥ Insert new ink absorber pads firmly into the rubber frame.
CANON PRINTER PIXAM 2220 SHOWING CODE 5B02 FREE
They will likely be on the right side of your printer, and will be located underneath the area where the ink cartridges rest when the printer is in standby mode.ģ Use a paper napkin or other disposable and absorbent material to soak up any excess ink that may be in the pads by pressing it down onto the top of the frame.Ĥ Pull the rubber frame free from the printer, wearing gloves to keep your hands clean.
Unplug the printer so that the cartridges will remain in their position.Ģ Locate the waste ink absorbers in their black rubber frame.
CANON PRINTER PIXAM 2220 SHOWING CODE 5B02 INSTALL
Open the printer as though you were going to install new ink cartridges, letting the cartridge cradle move to the center of the printing unit.
Ę613 CY7C68013 EZ-USB FX2 USB 2.0 Development Kit # The latest version can be obtained from # Send entries as patches (diff -u old new). # If you have any new entries, send them to the maintainer. a/drivers/staging/usbip/userspace/usb.ids PKG_CHECK_MODULES(, )ĭiff -git a/drivers/staging/usbip/userspace/usb.ids b/drivers/staging/usbip/userspace/usb.ids a/drivers/staging/usbip/userspace/configure.ac
Usbip.h usbip_common.h vhci_driver.h stub_driver.h)ĭist_man_MANS := $(addprefix doc/, usbip.8 usbipd.8 usbip_bind_driver.8)ĭiff -git a/drivers/staging/usbip/userspace/configure.ac b/drivers/staging/usbip/userspace/configure.ac a/drivers/staging/usbip/userspace/Makefile.am Overridden using `./configure -with-usbids-dir='.ĭrivers/staging/usbip/userspace/Makefile.am | 5 -ĭrivers/staging/usbip/userspace/configure.ac | 18 +-ĭrivers/staging/usbip/userspace/usb.ids |13209 -ģ files changed, 2 insertions(+), 13230 deletions(-)ĭelete mode 100644 drivers/staging/usbip/userspace/usb.idsĭiff -git a/drivers/staging/usbip/userspace/Makefile.am b/drivers/staging/usbip/userspace/Makefile.am USBIDS_DIR is set inĬonfigure.ac to a default of /usr/share/hwdata/. Inclusion of the usb.ids file is redundant. Next in thread: matt mooney: " staging: usbip: userspace: cleanup README".Previous message: matt mooney: " staging: usbip: userspace: add name to AUTHORS".Next message: Jack Wang: "Re: LIBSAS: fix libsas link error issue".Linux-Kernel Archive: staging: usbip: userspace: remove usb.ids file staging: usbip: userspace: remove usb.ids file From: matt mooney
0 kommentar(er)
